Remove Xbox Hard Drive

Replaced Xbox 360 Driver

Replacing the laser is hard. Get help from the community. Insert the flat end of a spudger and pry upwards to release the last remaining latch located above the eject button. You might be prompted to restart when finished. Any particular reason for that?

Insert the long, thin stick between the side panel and the case and unhook the four clips holding the interior piece of gray plastic to the case. Pull off the back panel and put it aside.

The laser isn't very easy to replace, but it is replaceable. In a similar fashion, free the clip at the front of the bottom bezel's left edge. Grasp the back portion of the lower case and lift it upwards to separate it from the console. While lifting up on the top bezel with your fingers, rotate the spudger away from the console to free the clip. Rotate the spudger away from the console, prying the edge of the fan vent up until the two plastic clips come free.

Set Up an Xbox Controller for Windows

While pressing down on the tool, push the lower and upper cases apart to separate the retaining clips. If you are performing such replacement for the first time, carefully read and understand all technical instructions - after all, you wouldn't want to screw up your prized console.

Orient the Xbox S so that the hard drive port is facing up and the faceplate is facing to the left. Go to Xbox Controller for Windows. Return the Xbox to its upright position on the table. Related Questions How do i replace a Lite on Xbox cd drive? Once you see the pop-up notification that the drivers have been installed, what are at risk drivers you can use your controller.

Video of the DayIt Still WorksAdd Your Answer

Replaced xbox 360 driver

Replace the hard drive cover before turning the console back on. Press the Xbox opening tool down into the two remaining clips near the power connector. Insert the flat edge of a spudger between the faceplate and the outer casing near the power button.

Microsoft Accessories

Video of the Day

The upper and lower cases are held together by seven release latches located on the back of the console. It's worth a thousand words. In the same manner described above, begin prying the left side of the top vent away from the top bezel.

Small - px Medium - px Large - px. While slightly lifting the front edge of the top vent, use the tip of a spudger to push the clips closest to the center of the top vent towards the inside of the console. Rotate the spudger away from the console, prying the vent up from the bottom bezel. Lift the left edge of the faceplate upward to release the last two clips securing the faceplate to the right case.

Throughout the following opening procedure, the finger of an Xbox opening tool can be used in place of a spudger. Test your Xbox wired controller by pressing a button, pulling a trigger, or moving a stick on the controller. Two cables still connect it to the motherboard. You need to replace the dvd drive.

Set Up an Xbox Controller for Windows

Xbox samsung drive replaced with lite-on? The optical drive and motherboard are paired and must be replaced together.

Did this resolve your issue? Use the tip of a spudger to release the clip securing the eject button to the metal casing. The clip should release, leaving the clips near the power connector as the only thing holding the upper and lower cases together.

Add or remove an Xbox 360 Hard Drive

On the right side of the console, locate the hard drive cover release. Release the clip near the front right corner of the top edge securing the right case to the faceplate.